Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 2024.6 .

Replacing the purge kit actuator

Important

Before replacing the actuator, unplug the purge actuator kit from the Asycube, remove the platform and remove the actuator kit.

Asycube 240Asycube 380/530

Step 1:

Remove the protective cover (A):

4 screws Tx10.

Step 2:

Disconnect the actuator by pulling on the connector, and not on the cable itself (B).

Step 3:

Unscrew the actuator block:

4 screws Tx10

Step 4:

Unscrew and open the support (1):

4 screws X0.

Unscrew the actuator (2):

1 screws Tx8.

Swap out the actuator (C).

Step 5:

Screw back the actuator in the support (1):

1 screws Tx8 - 0.8Nm.

Close and screw support (2):

4 screws X0 - 0.6Nm.

Step 6:

Screw back the actuator block on the main plate:

4 screws Tx10 - 1Nm

Step 7:

Plug in the actuator (D).

Step 8:

Screw the protective cover (E) back into position:

4 screws Tx10 - 0.6Nm.