Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 2024.6 .

First startup

This chapter guides you from unpacking your elements to the start of your Asycube.

Mount the Asycube

• Unpack the Asycube

• Use the holes in the base plate of the Asycube ( see Mounting the Asycube) to fix it to a solid base with the following screws :

Asycube 50	M5
Asycube 80	M5
Asycube 240	M6
Asycube 380	M8
Asycube 530	M8

Tip

Refer to section Mechanical integration to get more information. A tight fastening of the Asycube to a solid base is necessary.

Connect your Asycube electrically

Connect your Asycube to a 24V DC power supply via an optional power cable.

Important

Incorrect wiring of 0V and 24V would cause irreparable damages and void the warranty.

(1*)	24V PELV S-Power*
(2*)	0V GND S-Power*
(3)	24V PELV Power
(4)	0V GND Power
(5)	EARTH

* Safety-Power has to be supplied to use backlight or outputs.

Fig. 3 Asycube 50/80/240 (left) Asycube 380/530 (right)

Characteristic	Asycube 50/80	Asycube 240	Asycube 380	Asycube 530
Voltage	+24 V DC + 5%	+24 V DC + 5%	+24 V DC + 5%	+24 V DC + 5%
Consumption	5A	5A	4 A	6A
S-power consumption	1A	3A	16 A	14 A

Tip

Refer to section Power connection to get more information.

Configure Ethernet communication (RJ45)

There are two ways to connect your Asycube. Either you choose to use our EYE+ system and can visit our documentation here . Or you can connect your Asycube to a computer and use our Asycube Studio software.

Change the IP address of your computer to be on the same network as the Asycube (Table 2).

Table 2 Asycube Default IP Address

Default IP address	192.168.127.254
Default subnet mask	255.255.255.0
Port	4001

Tip

Check How to change the IP Address on your Windows PC? if you need help changing your computer’s IP address.

Note

Refer to section Communication to get more information.