Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 2024.6 .

Backlight synchronization

A standard M8 three-pins female cable enables to synchronize camera acquisition and Asycube backlight illumination, it must be connected as follows:

../../_images/backlight_synchronization.png

Fig. 26 Backlight synchronization

Pin

Signal

Cable (option)

(1)

Not wired

Braun

(2)

0V GND

blue

(3)

+24 V pulse (illumination sync.)

black

Connector type (on the Asycube side) M8,3P, male.

Note

This connector is not needed if you are using EYE+ to control your Asycube.

Tip

The backlight can also be triggered via a software command, refer to Backlight.

Note

The Asycube Backlight illumination time corresponds to the length of the pulse signal.