Recover IP address using default IP address

The following procedure explains how to reboot the Asycube on the default IP address, subnet mask and tcp port number to be able to modify IP address, subnet mask and tcp port number when they are unknown and cannot be found. Following this procedure, you are able to connect on the Asycube with default parameters and then modify unknown parameters.

Asycube 50/80Asycube 240Asycube 380/530

Step 1:

Remove the hopper Unscrew the 4 screws (A) and remove the cover (B)

Use an torx key size 10

Step 2:

Place selector 1 in “on” position (C)

Step 3:

Disconnect and reconnect the power cable (or switch off and switch on the power on the Asycube).

The Asycube will take the default parameters by the new startup :

IP: 192.168.127.254

SubnetMask: 255.255.255.0

TCP Port: 4001

Step 4:

Parameters in memory can now be modified (by direct access with commands to the Asycube, by functions in dll or by Asycube configuration page in HMI (see relative documentations for more details)).

Step 5:

When parameters are defined as desired, replace selector 1 in position (D).

Step 6:

Disconnect and reconnect the power cable (or switch off and switch on the power on the Asycube).

The Asycube will take the parameters defined by the new startup.

Step 7:

Replace the cover (B) and screw the 4 screws (A)

Use an torx key size 10 (0.9Nm)