電源接続

重要

• Before supplying power to the Asycube, check that your distribution voltage is the same as the nominal voltage (24 VDC).

• 公称電圧は、PELV 回路（保護特別低電圧回路）を使用してください。

• Incorrect wiring of 0V and 24V can cause irreparable damages and void the warranty.

• Strictly follow the power supply recommendations described in this section for your Asycube type.

図 21 電源コネクタは、Asycube 50/80/240（左）で、Asycube 380/530（右）にあります

表 3 Power connector pinout

ピン	信号の説明	ケーブル（オプション）
(1)	24VDC PELV S-電源	１
(2)	0V GND S-電源	２
(3)	24VDC 電源	３
(4)	0V GND 電源	4
(5)	アース	PE

表 4 Power connector type

	50/80/240	380/530
コネクタタイプ（アジキューブ側）	M16、5極、雄ねじ	ハーティング 09 12 005 3004

表 5 Power ratings

Characteristics	Asycube 50/80	Asycube 240	Asycube 380	Asycube 530
電圧	24 VDC +5%	24 VDC +5%	24 VDC +5%	24 VDC +5%
Current consumption on Power	5 A	5 A	4 A [1]	6 A [1]
Current consumption on S-Power	1 A	3 A	16 A [1]	14 A [1]
消費電流の合計	6 A	8 A	20 A	20 A

[1] (1,2,3,4)

For Asycube 380 and 530, two different power supplies must be used for S-Power and Power

Asycube 50/80Asycube 240Asycube 380/530

注釈

Both Power and S-Power can be connected to a single power supply or to two different power supplies. Select your power supplies with a nominal current rating as recommended in 表 5 with a current reserve of 150% for 3 seconds. The 0 V-GND and Earth signals of the two supplies are connected inside the Asycube.

注釈

S-Power is the safety power for the backlight. Cutting S-Power ensures that the backlight stays OFF.

The following connection schematic shows the way to connect the Asycube depending if your application requires using an external relay to ensure that the backlight is safely switched off or not. In any case, both Power and S-Power have to be supplied for using the backlight.

図 22 安全リレーなしと安全リレーありの電源接続