Gateway connection

電源接続

Connect the 24VDC (130 mA) power supply on the naked plug provided with the Gateway

../../../_images/gateway_power_supply_cc_link.png — 図 121 Gateway power supply

Asycube connection

Connect the Gateway X2-IN port to the Asycube communication port with a RJ45 cable (See 図 122). The Asycube feeder MUST have its IP Address set to its default value 192.168.127.254. The IP Address of the Gateway X3 port is 192.168.127.1

../../../_images/gateway_ethernet_connection_cc_link.png — 図 122 Gateway ethernet connection

Connect the Gateway to the machine controller

Connect the Gateway X3 port to the machine controller CC-Link with a CC-Link cable.

../../../_images/gateway_cc_link_connection.png — 図 123 Gateway CC-Link connection

Power ON

Switch the power supply ON to supply both the Asycube and the Gateway. Check the status of the Gateway LEDs:

SYS: steady green ON.
APL: blinking green with 2s OFF and 0.5s ON or steady green ON (if the machine controller runs).
X2 LINK IN (CH0) L/A: steady green or blinking green.
X3 LINK: steady green.
Other LEDs may also switch on or blink.

../../../_images/gateway_overview_cc_link.png — 図 124 Gateway Overview

Modify the station address

In some cases, you will have to modify the station address of the Gateway. The station address is defined by the two hardware switches. The address ranges from 1 to 64. Use a small flat screwdriver to turn the switches to the desired address.

../../../_images/hardware_switch_change.png — 図 125 Hardware switch to change the station address